IIRC the Shure Beryllium shanks had to be 'deposited' rather than machined (aluminum cantilevers are extruded/pulled to size, mechanically) and unfortunately that requires nuclear-level fume extraction and multiple clean-rooms or people (i.e. your shure workers) get beryllium poisoning. It's not nice, and is the reason there's no more beryllium cantilevers.
One problem with the Shure MM designs is that they all have an electrical impedance that causes progressive loss of high frequencies, typically starting around 12KHz. The manufacture of the cantilever/magnet assembly is rigged to add a second mechanical resonance to raise the output in this range and keep the response ideally flat to 20KHz. It's a juggling act with very tight tolerances, and is I think the reason for the known variability on the Shure replacement styli. The V and Vx were the top-of-the-line design, and I think they were much more consistent than during the v15/3 era.