新手上路
五星級會員
- 舊站積分
- 3604
- 舊站發表文章數
- 5787
|
關於Room Gain 找了些資料, 集中放在此處供參考討論.
1. 對於Room Gain的描述, 這段可以參考看看 : interesting discription about room gain and frequecy below 20hz
Oftentimes Room Gain in HT refers to the sub-set of Pressure Vessel Gain (PVG), and Boundary Gain.
Boundary Gain is just that; increasing the gain by the addition of a boundary.
Beginning with a full spherical space, the ground merely halves the previous full space. This halving, theoretically mirrors another like powered driver, thereby resulting in a theoretical 6db gain. Each subsequent halving of space, with the addition of another boundary, also results in a theoretical 6db gain.
The maximum added SPL for each boundary is 6 dB per boundary.
So full corner loading adds 18 dB, less whatever is lost through the boundary. Boundary gain is only frequency limited to 1/8th the wavelength. Regarding a sub crossed at 80 Hz, you have a 14 foot, or 168 inch, wavelength. If the sub-woofer's drivers are within 21 inches of all three boundaries (for corner loading), you will get boundary gain up to 80 Hz.
Pressure Vessel Gain (PVG) is the scenario whereby the longest dimension of the room can no longer support full propagation of the waveform.
At this point, the acoustic propagation transitions to acoustic pressurization. The manner in which the sound is reproduced into the space changes from a normal cyclic propagation, to pressurization because the wavelengths are too big for the space.
The frequency at which this occurs is approximately the point whereby half the wavelength of a given frequency is equal to the rooms longest dimension. So, a 20 hz frequency has a wavelength 56.5 feet. So half of that, 28.25 feet, is the point of transition. Any frequency below that point pressurizes the room, and any frequency above that point propagates freely. So in this room that's approximately 28 feet in the longest dimension, from 20 hz downward, the room gives back acoustically.
At this frequency, the results are a gain in acoustic pressures in the room that grows as the frequency decreases. This acoustic support reciprocity, is theoretically 12db per octave. The percentage of the 12 db/octave gain one achieves, entirely depends on the integrity of the boundary walls and surfaces. If it was the theoretical concrete bunker, a full 12db/octave boost would occur. Typically, somewhere between 6-10 db octave could result. Also, in addition to the walls and surfaces flexing, other aspects may affect the point at which room gain begins. Furniture, cabinets etc, anything that consumes a certain measure of cubic feet, may slightly alter the transition frequency merely because the items take up space. |
|