忘記密碼
 立即註冊
查看: 1041|回覆: 1

Wadia 討論區!

  [複製鏈接]

105

主題

8402

回帖

0

積分

新手上路

藍稜

舊站積分
1125
舊站發表文章數
7192
發表於 2006-8-24 23:30:09 | 顯示全部樓層 |閱讀模式
可能版上用的人也不少,

藉此機會交流交流,或者有新的調音方式也可提出分享!~
[URL=http://www.myav.com.tw/bbs/showthread.php?s=&threadid=384025]音響專線怎麼拉 [/URL]

26

主題

1689

回帖

100

積分

新手上路

四星級會員

舊站積分
3261
舊站發表文章數
1711
發表於 2006-8-27 23:00:50 | 顯示全部樓層
Since no one will respond to it, here are some email exchanges among 3 amigos.  Hope it is better than nothing.  

Wadia is Wadia -- high definition.

- Used Wadia to drive power amp directly via balance cable (AQ Emerald) achieved the highest resolution, but as usual --- lower end is not as delicious. (I'm a bass hunger)

- Will try Aural Symphonic cube power cord, I have 3, so will also try it on both 860 and power amp to see if it can boost the lower frequency properly.  It was used to boost 300S and Martin Logan but caused too much lower frequency and failed tonal balance so I retired it.  A thick wood amp stand also may boost the lower end a bit.

- Also will try unbalance direct connect via kimber and other silver cables

- Wadia 860 with pre-amp:  lower end is fuller, dynamic seemed dropped a bit, resolution and clarity also dropped. :-(

- I guess AQ Diamond type of interconnect cable can enhance lower frequency without hurting higher frequency. Don't have this on hand :-(

Some new findings over this weekend are:

- XLR connection sounds better than RCA connection via the same cable model. Not sure if it's because of Wadia balance output sounds better or Classe balance input sounds better or both.

- Some how Wadia 860 + Kimber KCAG/RCA = tonal unbalance.  It sounds .... quite strange.

- Use Aural Symphonic Cubed power cord on Classe can boost lower end, but when use Wadia 860 to drive Classe directly, even with this power cord, the mid range does have enough quantity.  If you like lower frequency, then a pre-amp is probably in need.

Please be careful on the 860 issue. I am going to sell my BRAND_X set and PERSON_Y, who owns an 8XXSE, considers that it is for convenience reason to keep his Wadia, not for sound. CD transport is, to me, is a doomed piece.

Using a simple sound card, modifying a few capacitors, send the digital signal which had been stored in a hard disk, to a decent DAC like Wadia 2000, Benchmark DAC-1... The sound quality has been proven better. So, before you droop on the 860, take another look on your computer. It IS going to get into your audio room. Sooner or later.

Received the Wadia last night and put it on the tough fights [] with Sony SCD-777ES and Accuphase DP-70.  The Sony has been left cold for 2 weeks.

Round 1 :

The Wadia just swiped the ass of both Sony and AQ. Sony was edgy and the AQ sounded colored in comparison.

Round 2:

Sony was left on for 4 hours.  Wadia sat on a 3" wood block where the Sony used to be.  Sony was moved to the bottom shelf of Solidsteel 6.4 stand.  Sony was much improved from last night but still sounded edgy.

Round 3:

I put 4 3" round industrial rubber shock absorber under the Sony.  The edgy-ness disappeared. Playing a CD and CDR of the same music on both machines, the Sony was slightly more forward than the Wadia.

Round 4:

Swaped the power cords of Wadia and Sony, both stock cords. They now sounded almost the same when the volumn were matched.  Now I have a Wadia in Sony's skin. []

Round 5:

After listening to more music, the Wadia still came out on the top.  It has the stength of both Sony and AQ combined: good resolution and tonal balance.  It also has better imaging density.  All of these were before any tweaking done on the Wadia.  
您需要登錄後才可以回帖 登錄 | 立即註冊

本版積分規則

Archiver|MyAV視聽商情網 test

GMT+8, 2026-11-18 21:13 , Processed in 0.053072 second(s), 26 queries .

Powered by MyAV!

快速回覆 返回頂部 返回列表