新手上路
五星級會員
- 舊站積分
- 32767
- 舊站發表文章數
- 5579
|
發表於 2009-5-26 00:31:36
|
顯示全部樓層
原發表者是 hsindao
[B]
The angle between the 2 lines in the above picture is 2 degree. The section within the red circle is about the length of a cantilever(針桿). Do you think you can easily tell that the cantilever is off by 2 degree?
Now look at the tracking error of Baerwald alignment (yellow line). The tracking error is about 1.3 degree at the inner circle.
Most people assume that the cartridge body is perfectly square and the cantilever is perfectly parallel/perpendicular to the sides of the cartridge body. Maybe you are lucky but maybe not. If your cantilever is off by 2 degree without you knowing it, the tracking error can be 3.3 degree instead of 1.3 degree and you can scratch you head for a long time and still do not have an answer. When setting up A, B point, one needs to make sure that it is the cantilever that is 正切, not just the sides of the body.
If your 尺規 does not allow you to align the center line, download this protractor. It looks like
Although not mentioned, I believe the A, B points were calculated using Löfgren method. Even if you set A,B points using the Baerwald method, you can still use that protractor to make sure the cantilever is indeed parallel to the 平行切線. A good magnifying glass will help.
[/B]
的確這會是個問題.
所以我在量以前,把唱頭拔下來看看是不是真的與殼邊平行.
而且我就真的碰過有不太平行的.說實在歪個兩度還蠻正常的.
不過如果Tracking Error 是1.3度,倒不見得會歪到3.3度.
相減變成0.7度,抵銷一大部份的可能性也有50%,
如果歪的方向和Tracking Error 的方向相同,加起來是3.3度,相信很容易聽得出來,
這時就有不少人會檢查唱頭是否有問題,不是用尺規猛量.
不過我現在用的這顆是看不出來的.
也許有,但肉眼無法查覺.
用尺規調整到定位後,的確不但內圈不破聲了,而且聲音像相機聚焦一般,
音像定位清楚,型體感稍小一點但輪廓清析.
p.s. 您的protractor 點進去無法連結. |
|