Anti-skating mechanism is problematic. It is rare that the anti-skating force will match side thrust force due to eventual friction forces. Some Thorens arms have 4 different scales for anti-skating: wet/dry x spherical/elliptical tip. The following graph shows imbalance of pressures on flank L/R for three representative designs of geometry (Stevenson/Baerwald/Loefgren) when anti-skating device is omitted (parameters: effective coefficient of stylus drag 0.3 and effective length of arm 231.2mm).
Note: theoretically the true coefficient of friction = 1/(SQRT(2) ) of the measured or empirical value since vertical stylus pressure is to be divided statically into VTF/(SQRT(2) ) each on groove flank. Then stylus drag force is [VTF/SQRT(2)]*2*coefficient of friction=VTF*SQRT(2)*coefficient of friction. This tricky calculation is based on armchair theories because the VTF cannot be actually divided evenly during stylus drag. Hence usually effective coefficient of stylus drag as empirical results is assumed to be theoretically equivalent to SQRT(2)*coefficient of friction. This coefficient of stylus drag 0.3 (coefficient of friction 0.212) for example is rather too small in comparison to the past investigations (coefficient of stylus drag 0.27-0.5 by Rangabe or 0.25-0.55 by JVC-1979 as shown in the following table).