新手上路
初級會員
- 舊站積分
- 0
- 舊站發表文章數
- 2
|
大家好,不好意思...我是剛入門自己diy的小焊工....所以不太清楚真空管在使用上的一些參數設計~想向大家請教一下我的想法是否正確?
網友的耳擴是WA6-SE~我把WA6用的6SN7>6DE7轉座賣他後~發現某些歌在特定頻率內會有破音的狀況~後來發現WA6的轉座SE沒辦法使用~我在AA上找到一些資訊~
**** the 6SN7 works fine on the wa6 but not so good with the 6SE. However, if you raise the cathode
resistance from 3.3K to approx. 4.7k,to avoid clipping, it sounds very very fine. i love this tube. you can
work with the resistance value to voice the amp to your headphone. playing with the cathode capacitance
will further refine the sound to your liking. the 6cg7/6fq7 and 6gu7 is almost as good as some NOS 6sn7.
it seems to be quieter than the 6sn7 in that there are zero mechanical or microphonic noise.
if you use black gate capacitors after the rectifier, make sure it's rated at above 200v. ideally it
should be at 350v.
看起來...是否把轉換座內陰極部份的線路~改多串上一顆1.4K歐姆的電阻就可以解決這問題呢??
謝謝大家.... |
|