新手上路
五星級會員
- 舊站積分
- 24833
- 舊站發表文章數
- 7074
|
對我,算是科學新知。唱盤的壓克力蓋子會因靜電把較輕的唱臂給吸起來。 [:O]
Vinyl Asylum 的討論串
RE: What to listen for in dustcover down/up/off test?, posted on September 9, 2009 at 17:02:52
geo770
In the extreme, listen for the tonearm skittering across the record, because static charge on the dustcover has attracted the tonearm and lifted it completely up from the grooves. Though I doubt it will do that normally, if you polish the dustcover immediately before lowering, or during playing, it could happen, especially to a light tonearm. That actually happened to me.
What you might try doing is taking a stylus force measurement with the dust cover off, and with it lowered, if possible. With the Shure SFG, you can start with it balanced with the cover up and then see what happens when it's lowered.
_____________________________
RE: Static charge from a dust cover can cause a light tone arm to rise -, posted on September 9, 2009 at 17:34:17
I'am going to summit this one to the Myth Busters.
_____________________________
its true, posted on September 9, 2009 at 18:20:54
hifitommy
Audiophile
for that reason i am glad i dont live in alaska where its arid from the cold. if the conditions are right it can happen.
thats what zerostats can be good for among other things.
...regards...tr
_____________________________
happened to me too.., posted on September 9, 2009 at 23:56:27
boneaus
many years ago with a light tracking V15III, possibly less than i gram downforce.
I was polishing the TT acrylic cover at the time. Scared the cr*p out of me.
What made it worse was lifting the lid caused the arm to crash back onto the moving LP.
Both LP and cart survived somehow. I'm sure the condition is easily replicated and no challenge for any myth-busters.
_____________________________
RE: happened to me too.., posted on September 10, 2009 at 08:11:08
geo770
In my case, it was a Thorens TD-110 with a TP-30 tonearm, designed for low mass, and an Audio Techinca 440MLa tracking at 1.7 grams.
After it happened, and I was over my WTF?? shock, I re-measured VTF with a Shure stylus force gauge, and it was OK; the dust cover was up, of course. Then I hit upon the bright idea of lowering the dust cover with the cartridge still balanced on the gauge. Sure enough, as I gently lowered the top, it went out of balance, towards the light tracking force end.
As far as I'm concerned, everyone *should* try their own "myth-busting" experiment with a suitable stylus force gauge. Maybe those with heavier arms, or arms of different compositions, will have no problem. But some may see a substantial effect - and tracking force can have a big impact on sound.[/FONT]
網友 geo770 用針壓計量測蓋子抬起來和降下來的差別,很有科學實驗意義。 |
|