忘記密碼
 立即註冊
樓主: chucky7

美國網路直售喇叭和超低音的經營生態和使用觀點

[複製鏈接]

34

主題

1311

回帖

0

積分

新手上路

Da Man

舊站積分
1718
舊站發表文章數
1326
 樓主| 發表於 2017-9-16 04:27:47 | 顯示全部樓層
Pressure vessel gain and boundary gain: Friend or foe??? [] [}]

Data-bass 測試的 JTR Captivator 1400 是2015年份的, 序號應該是 001. 我的年份也是 2015 的.

同樣的失真圖中

在 21.68 Hz, 輸出為 110.6 分貝時, THD 是 18.5%...

在 20 Hz, 輸出為 110.9 分貝時, THD 是 12.7%...

在 12.53 Hz, 輸出為 101.9 分貝時, THD 才突破20%.

[]

249

主題

3萬

回帖

220

積分

新手上路

上將

舊站積分
11603
舊站發表文章數
26283
發表於 2017-9-16 10:06:17 | 顯示全部樓層
原發表者是 chucky7
[B]
皇帝位的 Group Delay:
[/B]


20HZ 以下的 GD有點高......
[url=http://www.myav.com.tw/market/showthread.php?s=&threadid=5991]進口超值--色差、同軸數位、S線[/url] [url=http://www.myav.com.tw/market/showthread.php?s=&threadid=127614]綜合商品區[/url] [url=http://www.myav.com.tw/market/showthread.php?s=&threadid=20459395]In-akustik 德國敏力線[/url]

34

主題

1311

回帖

0

積分

新手上路

Da Man

舊站積分
1718
舊站發表文章數
1326
 樓主| 發表於 2017-9-16 11:50:54 | 顯示全部樓層
原發表者是 ups
[B]20HZ 以下的 GD有點高...... [/B]

Group Delay, 瀑布圖, Spectrogram 不是都應該從室外頻率響應跑出來的嗎?

這是data-bass 上測的 JTR Captivator 1400 的Group Delay:



請問從室內105分貝的頻率響應可以看到什麼?

249

主題

3萬

回帖

220

積分

新手上路

上將

舊站積分
11603
舊站發表文章數
26283
發表於 2017-9-16 12:01:19 | 顯示全部樓層
原發表者是 chucky7
[B]
Group Delay, 瀑布圖, Spectrogram 不是都應該從室外頻率響應跑出來的嗎?

這是data-bass 上測的 JTR Captivator 1400 的Group Delay:



請問從室內105分貝的頻率響應可以看到什麼? [/B]


應該是喇叭單體延遲....
[url=http://www.myav.com.tw/market/showthread.php?s=&threadid=5991]進口超值--色差、同軸數位、S線[/url] [url=http://www.myav.com.tw/market/showthread.php?s=&threadid=127614]綜合商品區[/url] [url=http://www.myav.com.tw/market/showthread.php?s=&threadid=20459395]In-akustik 德國敏力線[/url]

34

主題

1311

回帖

0

積分

新手上路

Da Man

舊站積分
1718
舊站發表文章數
1326
 樓主| 發表於 2017-9-16 12:16:13 | 顯示全部樓層
From http://data-bass.com/know-how

[B]Data-bass 上對 [B]Group Delay[/B] 的解說:[/B]

A group delay graph is derived from previous measurements. This measurement indicates how much delay or storage of energy versus frequency is taking place in a system. Larger values in MS indicate more latency or energy delay.Ideally there would be zero group delay indicating an incredibly well damped system. In reality there is always some. Generally it is held that as long as the delay is below 1.5 cycles it is inaudible and most who claim to hear differences in delay between speakers would say that anything less than 1 cycle of delay is nothing to worry about. Additionally the deeper in frequency, the longer the wavelength and less sensitive our ears are to it the less audible a long group delay will be. Generally anything below 25-30Hz is not regarded as of much concern unless really bad. For example 40ms of delay at 25Hz is probably not a big deal and not very audible but 40ms of delay at 80Hz is going to be much more audible and of concern. Typically sealed, IB and other lower order systems offer the least amount of delay...Bass reflex systems typically have increased delay near the resonator tuning. Even higher order systems like horns and Bandpass enclosures can have more group delay and more complex delay plots. Additionally equalization and other signal processing, such as high pass filters and boost or parametric signal shaping can increase the group delay. [B]Usually this measurements indicates nothing of concern unless the group delay is exceeding 1.5 cycles above 25Hz. [/COLOR][/B]

From http://data-bass.com/data?page=system&id=117&mset=129

[B]Data-bass 上對 JTR Captivator 1400 Group Delay 的評語[/B]

Group delay and decay of energy is [B]well controlled[/COLOR][/B] until down near 20Hz where the group delay just reaches 1 cycle. Near the vent tuning and high pass filter the delay does grow to around 1.5 cycles but [B]at such a low frequency this is of no audible consequence.[/COLOR][/B]

249

主題

3萬

回帖

220

積分

新手上路

上將

舊站積分
11603
舊站發表文章數
26283
發表於 2017-9-16 12:54:08 | 顯示全部樓層
原發表者是 chucky7
[B]From http://data-bass.com/know-how

[B]Data-bass 上對 [B]Group Delay[/B] 的解說:[/B]

A group delay graph is derived from previous measurements. This measurement indicates how much delay or storage of energy versus frequency is taking place in a system. Larger values in MS indicate more latency or energy delay.Ideally there would be zero group delay indicating an incredibly well damped system. In reality there is always some. Generally it is held that as long as the delay is below 1.5 cycles it is inaudible and most who claim to hear differences in delay between speakers would say that anything less than 1 cycle of delay is nothing to worry about. Additionally the deeper in frequency, the longer the wavelength and less sensitive our ears are to it the less audible a long group delay will be. Generally anything below 25-30Hz is not regarded as of much concern unless really bad. For example 40ms of delay at 25Hz is probably not a big deal and not very audible but 40ms of delay at 80Hz is going to be much more audible and of concern. Typically sealed, IB and other lower order systems offer the least amount of delay...Bass reflex systems typically have increased delay near the resonator tuning. Even higher order systems like horns and Bandpass enclosures can have more group delay and more complex delay plots. Additionally equalization and other signal processing, such as high pass filters and boost or parametric signal shaping can increase the group delay. [B]Usually this measurements indicates nothing of concern unless the group delay is exceeding 1.5 cycles above 25Hz. [/COLOR][/B]

From http://data-bass.com/data?page=system&id=117&mset=129

[B]Data-bass 上對 JTR Captivator 1400 Group Delay 的評語[/B]

Group delay and decay of energy is [B]well controlled[/COLOR][/B] until down near 20Hz where the group delay just reaches 1 cycle. Near the vent tuning and high pass filter the delay does grow to around 1.5 cycles but [B]at such a low frequency this is of no audible consequence.[/COLOR][/B] [/B]


謝謝你的連結解說.....
[url=http://www.myav.com.tw/market/showthread.php?s=&threadid=5991]進口超值--色差、同軸數位、S線[/url] [url=http://www.myav.com.tw/market/showthread.php?s=&threadid=127614]綜合商品區[/url] [url=http://www.myav.com.tw/market/showthread.php?s=&threadid=20459395]In-akustik 德國敏力線[/url]

0

主題

110

回帖

0

積分

新手上路

二星級會員

舊站積分
42
舊站發表文章數
110
發表於 2017-9-16 13:02:06 | 顯示全部樓層
原發表者是 kenhugh
[B][8D] 那原文 我來白話點說看看好了

作者說的意思是說當評價重低音用快速不是那麼準確  他覺得所謂的快速其實是在大SPL輸出下的感受 當你用更低頻的部份做增益或增加低音整體音壓增益下 你都會覺得速度變快了....

筆者的意思是說其實主要是低音頻段上的音壓增益變化讓人覺得聲音變快了 <<比較接近作者原意就是說動態大 [/B]


所以不同顆超低音聽起來的速度感不同,應該是沒有爭議了,
這本就是一個聽者的形容詞而已,無須太過講究,正名人士可以休息了,不用一直在這件事情上打轉。

944

主題

1萬

回帖

50

積分

樂特音響

舊站積分
9655
舊站發表文章數
13910
發表於 2017-9-16 13:11:30 | 顯示全部樓層

34

主題

1311

回帖

0

積分

新手上路

Da Man

舊站積分
1718
舊站發表文章數
1326
 樓主| 發表於 2017-9-16 13:39:23 | 顯示全部樓層
以下是 Marc 網友在6月多南加州地區重低音網聚期間測試的反射式重低音產品得到的 CEA 2010 最大音壓的匯總:



他這次共測試了4台反射式重低音. 其中 Data-bass 在更早也測過了 JTR Captivator 118HT. 所以, 我可以拿這些數聚的差異來調整 Marc 得到的數據. 調整過的數據就可以粗略地和 Data-bass 上互相比較. 也不再是懶覺比雞腿了...

34

主題

1311

回帖

0

積分

新手上路

Da Man

舊站積分
1718
舊站發表文章數
1326
 樓主| 發表於 2017-9-16 14:04:19 | 顯示全部樓層
http://www.avsforum.com/forum/61 ... 4.html#post54760470

以下是 Marc 就他這次網聚 聽過/測試過 的所有反射式重低音產品排名. 看起來短期內他不會再出書面報告了... 他現在打算研究測試方式, 希望他不要貪多嚼不爛才好...

整體排名:
1a. JTR CAPTIVATOR 118HT
1b. JTR CAPTIVATOR 1400 (2015)
2. RYTHMIK FV18
3. PSA V1801
4. SEATON SOUND MFW-15 TURBO

音質排名:
1. RYTHMIK FV18
2. JTR CAPTIVATOR 118HT
3. JTR CAPTIVATOR 1400 (2015)
4. PSA V1801
5. SEATON SOUND MFW-15 TURBO

體感震感排名:
1. JTR CAPTIVATOR 1400 (2015)
1. JTR CAPTIVATOR 118HT
2. PSA V1801
4. SEATON SOUND MFW-15 TURBO
5. RYTHMIK FV18
您需要登錄後才可以回帖 登錄 | 立即註冊

本版積分規則

Archiver|MyAV視聽商情網 test

GMT+8, 2026-11-19 15:26 , Processed in 0.103344 second(s), 41 queries .

Powered by MyAV!

快速回覆 返回頂部 返回列表