忘記密碼
 立即註冊
樓主: R.S.H.

讓大家更認識號角喇叭

[複製鏈接]

3

主題

321

回帖

0

積分

新手上路

二星級會員

舊站積分
223
舊站發表文章數
311
發表於 2013-8-23 10:39:06 | 顯示全部樓層

Re: Re: horn

原發表者是 johmsonlu
[B]A 100% efficient speaker system has theoretically zero distortion.   Horn systems are approx 20% efficient, cone speakers are approx 2% efficient.   Horn systems are capable of giving a closer approximation of musical reality.   With precision alignment their performance achieves the highest performance in linearity, fidelity, dispersion, efficiency and power.   But horn systems require critical alignment that is rarely achieved.   The 3 octave rule allows for no errors because errors are magnified. [/B]

Historical Note.   Horn speaker systems of all sizes have been used in cinemas for approx 70 years and are heard by everyone but rarely seen except at rock concerts.   Horn system technology was researched in detail during the 1950s and virtually no new information has been discovered since.
1950s   Giant cinema horn system   height 12ft / 4m   x   width 15ft / 5m
Horn systems are expensive to manufacture.   Quality compression drivers are machined to exact tolerances within microns.   Unfortunately today, selling is driven by marketing not by consumer understanding.   Marketing profit can represent 80-90% of product cost.   Cost cutting in manufacture relates to errors that magnify acoustical distortion within the music.   Many senior engineers have expressed disgust of these practices.   This text honours the original engineers who』s love of music and acoustic technology stood above ego and personal gain.   This text is also a contradiction to much of the present marketing hype and to those whose identities are attached to brand names, and model numbers.
A horn encapsulates the air in front of the speaker (driver).   The vibrating air is focused forward at higher efficiency.   To achieve this the horn must turn smoothly through 90deg (exponential).   Air cannot slip sideways, therefore air mass (radiation resistance) to the speaker (driver) is constant.   With no horn the cone movement increases 4 times for each octave decrease including a widening of dispersion.   With a horn the cone (diaphragm) movement is reduced.

63

主題

1997

回帖

0

積分

新手上路

四星級會員

舊站積分
2305
舊站發表文章數
1801
發表於 2013-8-23 11:39:54 | 顯示全部樓層

Re: Re: Re: horn

原發表者是 johmsonlu
[B]
Historical Note.   Horn speaker systems of all sizes have been used in cinemas for approx 70 years and are heard by everyone but rarely seen except at rock concerts.   Horn system technology was researched in detail during the 1950s and virtually no new information has been discovered since.
1950s   Giant cinema horn system   height 12ft / 4m   x   width 15ft / 5m
Horn systems are expensive to manufacture.   Quality compression drivers are machined to exact tolerances within microns.   Unfortunately today, selling is driven by marketing not by consumer understanding.   Marketing profit can represent 80-90% of product cost.   Cost cutting in manufacture relates to errors that magnify acoustical distortion within the music.   Many senior engineers have expressed disgust of these practices.   This text honours the original engineers who』s love of music and acoustic technology stood above ego and personal gain.   This text is also a contradiction to much of the present marketing hype and to those whose identities are attached to brand names, and model numbers.
A horn encapsulates the air in front of the speaker (driver).   The vibrating air is focused forward at higher efficiency.   To achieve this the horn must turn smoothly through 90deg (exponential).   Air cannot slip sideways, therefore air mass (radiation resistance) to the speaker (driver) is constant.   With no horn the cone movement increases 4 times for each octave decrease including a widening of dispersion.   With a horn the cone (diaphragm) movement is reduced. [/B]
so ,actually the role of "horn"which it playing...

is actually
"attenuating"not "magnifing" the efficiency..... no matter it is 0%, 20% or even so much as 90%..etc

that's  the issue we're arguing before ,and my point of view was severly condemned  as well by then!  

most of webpal vote for the pro(not professional at this point I bet)without even  take a glance at  the attenuation formula documented and  quoted by Mr.鄭厚錡.....

"Unfortunately today, selling is driven by marketing not by consumer understanding.   Marketing profit can represent 80-90% of product cost.   Cost cutting in manufacture relates to errors that magnify acoustical distortion within the music.".......

what if we translate above saying into chinese..... it would probly be a diaster on this webside , that's for sure!   

"To achieve this the horn must turn smoothly through 90deg (exponential).   Air cannot slip sideways",.... "short plum leaks quickly"that's it!  

the idael d

egeneration rate of AIR PRESSURE vs
Increasing of CUTTING AREA of "E"- HORN" 1s approximately 1-2%/per cm(related to sound frequency required) as I showed it on the literature above as an example for
demonstration !.................

thanks for your precious information! best regrds........... sincerly sfb3

20

主題

4368

回帖

0

積分

新手上路

五星級會員

舊站積分
508
舊站發表文章數
4372
發表於 2013-8-25 23:29:06 | 顯示全部樓層
Efficiency numbers alone can be misleading.  Horns generally have stored energy from compression drivers.  The main purpose was initially to focus sound to a specific pattern and distance.  Stored energy, however contributes to perceived music distortion which may or may not be shown with single tone measurements.

The benefits are the the power response is focused in a fashion that helps reduce the BL related distortion at specific playback levels.
[url="http://augene.blogspot.com"]Hear The REAL Thing[/url] [url="http://www.augene-audio.com.tw"]感受藝人的心靈[/url]

3

主題

321

回帖

0

積分

新手上路

二星級會員

舊站積分
223
舊站發表文章數
311
發表於 2013-8-26 08:49:04 | 顯示全部樓層

horn

3

主題

321

回帖

0

積分

新手上路

二星級會員

舊站積分
223
舊站發表文章數
311
發表於 2013-8-26 09:39:28 | 顯示全部樓層

Re: horn

50年代.低音號的使用就相當的成熟了,只是體積太大而無法普遍流行..我的經驗是低音號能到50hz就可以了.可是體積還是很大
From :single driver website綱站
For a bass horn with a flare frequency Fo of 50 Hz, the free space mouth will be 3.8 m2 or 38000 cm2. This is very large.
3.8米平方的低音號開口就=2米x1.9米,龐然大物放在室內,能接受的家庭實在不多,,

3

主題

321

回帖

0

積分

新手上路

二星級會員

舊站積分
223
舊站發表文章數
311
發表於 2013-8-26 10:24:55 | 顯示全部樓層

350hz horn

350hz 的號角用在500hz的Altec 288及JBL 2440.絕對出好聲

63

主題

1997

回帖

0

積分

新手上路

四星級會員

舊站積分
2305
舊站發表文章數
1801
發表於 2013-8-27 08:53:25 | 顯示全部樓層

Re: 可以這樣想!...........

原發表者是 sfb3
[B]波長1/4= 擺幅....

急速 不自然平滑衰簡或增加-  
突然"壓縮"或"減壓"....
物急必反..駐波或反駐波由來 (指數型每公分約兩趴變化)


膜到頸長度 各種不同頻率波長"怕推擠打架"才用相位錐  200hz以下"不同低頻推擠打架...不易detect且難以管理(原因如前篇訴說)且膜-頸距大約至少要42.5cm 且膜前後chamber比例差太大前後震動會"不順"

會打架的話 各種頻率 擺幅一倍 就會打架,不必 兩倍 三倍 四倍(整個波長)才打架......

下次打架時機會是在"筒口"

整個聲音路徑要從 "膜"開始!結束於口"


手酸了!下次自己打!當作我也不會想像也可以[] [] [] [xx(] [xx(] [xx(] [|)] [|)] [] [] [] [/B]
依照S兄POLL文 入/4應該=10.6CM左右 沒有人發現我多算了30CM嗎?發文當時我就發現了!但忘記了......特此修正並致歉![:I] [:I] [:I] [:I]

63

主題

1997

回帖

0

積分

新手上路

四星級會員

舊站積分
2305
舊站發表文章數
1801
發表於 2013-8-27 08:59:32 | 顯示全部樓層

報歉!S 兄...

原發表者是 soongsc
[B]Efficiency numbers alone can be misleading.  Horns generally have stored energy from compression drivers.  The main purpose was initially to focus sound to a specific pattern and distance.  Stored energy, however contributes to perceived music distortion which may or may not be shown with single tone measurements.

The benefits are the the power response is focused in a fashion that helps reduce the BL related distortion at specific playback levels. [/B]
請教一下 ,B L是甚麼縮寫...."BROCASTING LEVEL"? BEAM LATENCY...OR OTHERS?[] [] [] 甘溫擂!

63

主題

1997

回帖

0

積分

新手上路

四星級會員

舊站積分
2305
舊站發表文章數
1801
發表於 2013-8-27 09:49:54 | 顯示全部樓層

Re: horn 有網兄願發表心得釋疑 比較一下有關.....

原發表者是 johmsonlu
[B] [/B]
這個horn形狀房間與一般居家四四方方格局的異同!  或 沙發放裏面放外面聽有何異同呢?,.........

純粹只能看圖說故事!,,,,我在思考及好奇的問題!

(因為數十年前我聽說日本大發燒友將大房子做成horn,不知道是甚麼形式的horn,...............

家中即horn內 家門口即horn外, 聽起來不知會是甚麼聲音!)[] [] [] []

63

主題

1997

回帖

0

積分

新手上路

四星級會員

舊站積分
2305
舊站發表文章數
1801
發表於 2013-8-27 10:14:33 | 顯示全部樓層

Re: 350hz horn

原發表者是 johmsonlu
[B]350hz 的號角用在500hz的Altec 288及JBL 2440.絕對出好聲

[/B]
我雖然沒看過這支(應該是現代號角)

不過以它的長度30cm左右ˍ 

.....膜 頸壓縮段加摺疊長度應該近於ev 放送頭內部所跑的逕1.8-2meter左右 ---

(ev 放送頭300hz分頻 可低至甚至150hz,)

木號角共鳴吸音反折射較好聽...但比金屬(cobra為鋁合金 內部有摺疊)不易延展!

這隻應該是塑料或碳纖製的吧![] [] [].....待續有空再寫!......................


---抱歉文短騙積分真的有愧..一切都是環境來造成的....[:I] [:I] [:I]
您需要登錄後才可以回帖 登錄 | 立即註冊

本版積分規則

Archiver|MyAV視聽商情網 test

GMT+8, 2026-11-19 14:53 , Processed in 0.107528 second(s), 41 queries .

Powered by MyAV!

快速回覆 返回頂部 返回列表