新手上路
五星級會員
- 舊站積分
- 3604
- 舊站發表文章數
- 5787
|
發表於 2017-9-30 01:04:54
|
顯示全部樓層
參考一下: 以下轉貼自Frequently Asked Questions @Rythmik Audio
Which has more SPL – subwoofer A or subwoofer B?
The important consideration here is that there are two numbers we can arrive at as an answer to this question. One is maximum SPL which is the most that you can measure without damage to the subwoofer. This is relatively simple to determine for a given frequency.
The other number is the maximum SPL which can be reproduced with low distortion, definition and accuracy.
In practice this is the more significant limitation of a subwoofer. Most subwoofers lack accurate bass at any level.
Typically even subwoofers normally considered high end are not able to reproduce what we would consider accurate bass at 10 dB less than their absolute maximum SPL.
While our subwoofers are not designed to impress with high SPL, the SPL they can produce without high distortion is higher than competitive subwoofers.
Maximum SPL at low frequencies (without considering distortion) is determined by the amount of air that the subwoofer can displace. In a sealed subwoofer, this is the only factor, but in vented subwoofers, the output from the vent must also be considered. In theory, a vent or passive radiator can contribute 6 dB in the bottom octave, but this gain can be reduced by port compression in vents and by the increase in mechanical stiffness of the passive radiator at high excursion.
The amount of air displaced can be limited by a number of factors that are difficult to estimate accurately. In practice, a maximum estimated SPL capability is of little use since it is not related to the distortion involved.
The following points should be considered:
*Higher excursion drivers will not necessarily have higher SPL
*Drivers designed for a very high excursion have significant compromises which result in an increase in distortion
*Higher amplifier power does not always mean more output
*While a vented subwoofer can have similar output at 20 Hz to two sealed subwoofers, the sealed subwoofers will have higher output above 40 Hz
If high output is important to you, in most cases the best way to achieve it is with a number of well-designed subwoofers.
Rather than buying one very expensive subwoofer with ultra high excursion and a massive power amplifier, we advocate multiple subwoofers with a sensible and intelligent design.
This removes the compromises used in the ultra high excursion ultra powerful subwoofer which we consider to be more useful for making noise than for reproducing music. Our subwoofers are superior in the areas that count the most – accuracy and value for money. In many cases they are superior in SPL and cheaper as well. This is only possible because we use superior technology.
其中不免有些老王賣瓜的字眼, 原則性的部分倒頗值得參考 |
|