新手上路
三星級會員
- 舊站積分
- 78
- 舊站發表文章數
- 895
|
發表於 2006-9-25 12:12:28
|
顯示全部樓層
原發表者是 ATP
[B]...
The extraordinarily low inductance, linear, high efficiency and deep
power handling, combined with an excellent damped-paper cone, and
completed by long excursion and deep power handling, make these
drivers unexcelled for wide band use. The Apollo changes benefit the
driver's performance for bass and midrange, and most importantly, for
both at the same time. They can be crossed much higher than any
other true woofer I know of, while retaining superb sound quality.
In summary, if you are in need of a good set of low distortion
subwoofers, the PL drivers will do the job very well, but if you have
a design that will require their use into the midrange, such as an
ultimate two-way with an unconventional high frequency unit (AMT, Manger, Unity, GedLee RSP, etc.) the Apollo units are not only a much
better option, they are I believe your best option. The "regular"
TD15 units aren't bad either.
[/B]
Hello ATP, thanks a lot for a thorough explaination of the differences. If I embark this venture, I will mostly like use a pair of Apollo or Post-Apollo drivers [;)] although I will have them cross at about 150hz according to a design I have seen. However, I will most likely end up using an digital active crossover like Tact or DEQX, which would perform phase correction, group delays, crossover and frequency response calculations for me. Due to the relatively high efficiency of this woofer, according to your expereince, which midrange drivers seem to have worked well with this driver if one were to attempt a 3-way design. By the way, do you also happen to have a frequency response graph to an Apollo driver? |
|