新手上路
五星級會員
- 舊站積分
- 4615
- 舊站發表文章數
- 3354
|
發表於 2017-11-9 09:25:17
|
顯示全部樓層
#1. 居家空間以 (THX) Reference Level 播放 "太大聲了",其理由、依據請看本串前文。
#2. 超低音和其他喇叭的相位配合調整,以「改變環繞擴大機中喇叭的 "距離設定數值" 並觀察 "分音重疊頻率的響應變化" 為依據」,是可行的方法之一。
『以為實際用尺量到的距離才是正確的 "距離設定數值","反而是錯的"』
『超低音喇叭的電路、數位音頻處理,以及低頻和房間的交互作用都可能添加時延或相移』
『玩儀測如 REW 需要去理解 "數據的意義"、"數據能為玩家提供什麼樣的協助"』
『耳聽也有 "一大堆功課要做",播什麼素材、聽什麼關鍵、如何進行評價、如何改進修正... 是要尋求可信的資源、經過一番學習的』
『詞彙、術語(梳狀濾波效應、Time Alignment...)不是反覆講就能深入瞭解其內涵,仍然是要學習....』
◎ 調整相位的目的是在分音頻率處獲得正確的相位對齊;時延、相移、距離是有相關性的 ~http://www.rythmikaudio.com/phase1.html (Rythmik Audio):
(Subwoofer phase alignment) How to adjust phase with a home theatre receiver:
The simple method is to compensate by changing the speaker distance setting on your receiver.
... our objective is to get correct phase alignment at the crossover frequency.
... "adding delay time in time domain" = "adding negative phase angle" = "subtracting physical distance in AVR".
◎ 環繞擴大機中的「喇叭距離設定」可以取代超低音喇叭上的「相位設定」,而且更好(用) ~http://www.seaton-sound-forum.com/post?id=4780172&highlight=phase (Mark Seaton):
Is the distance setting in a pre-amp the same as a continuous phase control?
In most cases you do want to keep the phase dial set to zero and use other efforts first. The main problem with a phase dial is that while useful, all it can do is add group delay to the subwoofer, when often we need to delay the speakers to the sub, which is the opposite of what a phase control does in the time domain. Testing with sine waves will give you better summation, and that is better than big cancellations, but it can be done better with delay.
You asked if phase and distance/delay are the same. They are related, but different. The difference is that a delay is constant with frequency, where a phase shift generally creates greater delay at lower frequencies than at higher frequencies. Both can allow you to get the main speakers and subwoofers better in sync, but they have different effects on the rest of the frequency range away from the crossover point. The only time I find myself using a phase control is when I don't have other adjustments available such as with a 2ch system or possibly with 2 or more subwoofers where there is no delay control. Even there, I often use an added low pass filter as I don't want to have the subs canceling at the lowest frequencies. Sometimes the phase knob can result in some improvements, but with delay available I haven't found it to be as useful a setting. In fact, I helped a dealer friend with a theater who had a pair of JL F113 subs and the phase adjustment was not enough get what looked like useful responses from the front/rear subs to work together properly. I'm pretty confident that delay would have worked much better based on what I was seeing. |
|