You can DIY hush box to cover LT150 plus external exhaust fans. In the advanced step, you can remove the top cover and internal fans. But the sealing must be very good to avoid dust getting in.
The noise comes from two internal fans. When LT150 is placed on the table, only one fan operates unless it is over heat. For ceiling mounting, both fans operate at the same time. That's why ceiling mounting is much noisy.
In your case of table mounting, you can try the following methods:
(1) Add ductworks to cover the exhaust fans. Let the exhaust air run in longer path and convert to other direction. No need to cover other part of the projector. So the heat can be transmitted to surrounding air.
(2) If you are not satisfied the noise level of the 1st method, you can try adding a enclosure without bottom ( 5 sides only) to cover the projector. Let the exhaust air (flowing in the ductwork) blow downward. There should be air intake port at the left hand side and the projector is placed close to the LHS of this enclosure.
(3) You can place a digital thermometer inside the enclosure to monitor the internal temperature. If the heat can't be transmitted effeciently, the temperature will keep going up. My hushbox is at 35-40deg after running over two hours. I think that's the safe temperature.
CKL,thank you for your suggestions and I think they're very helpful!
艘善斕腔泃赽艘荌r鏽珨茞碟(喜渡躲斕腔HUSHBOX船祥嗣)賸珨狟ㄛ
1﹜扂覜紒硐岆樓改L奪灉ˍ麟L諳腔ㄛ婑秞廌湮--珩衄褫夔岆秪扂]衄酕躇寯腔齬餫奪顈﹝
2﹜扂Ⅳ碟拻鬳猾寯ㄛ硐隱源衄蔉螹腔珨鬳嶱溫ㄛ婑秞隴鞞苤竭嗣﹝芘荌C溫婓碟赽夎掀廌蕞輪酘忒珨虳腔弇離ㄛ]衄阼筳熇苀熂蛅皆移蟣f筳熇苀漍暱兔^源蔉螹ㄤ封媔傺嚁N善30僅眕奻(弅22ㄛ彆芘荌C祥溫婓碟夎腔媔25-27僅ㄛ扂岆Ⅵ媔菁窒溫婓芘荌C粕帡氯o蜇輪y腔)ㄛ秪扂祥眭耋假媔鉓晻畋麤]衄詫餞鴦狟﹝斕挲腔酕]衄菁腔碟赽K齬餫蜊砃狟源餚岆疑翋砩ㄛ扂艘﹝
3﹜扂覜紒森C追堤腔婑秞螿薹廌詢ㄛ援芵薯廌ㄛ垀眕扂砑樓c柲秞蹬腔虴彆餚疑珨虳﹝斕挲儸ˋ
(1) If you use plastic board to make the hushbox, the noise level will be further lowered because its density is much higher than paper board. Using acoustic absorber is a good idea. If the enclosure can't fully cover the projector, then the improvement is minimal. It may also affect the operation of the remote control.
(2) Regarding HTPC, I prefer Geforce2 MX (its filter was removed) to my old G400 because the pricture from Geforce2 is more punchy and sharper. I've tried Radeon 8500LE briefly. Yes its DVD peformance is good but there is problem of the present driver. Considering the price difference and the driver, I bought Radeon 7500 (ATI original box set) last night. I will install it tonight. I will have some screen shots later. My present HTPC is PIII800+384M RAM+Radeon 7500+Audigy+Pinnacle PCTV+WinMe+Zoomplayer(DVD decoder from either PowerDVD XP, WinDVD 3.1, ATI DVD player).