新手上路
三星級會員
- 舊站積分
- 2946
- 舊站發表文章數
- 961
|
發表於 2013-6-27 17:46:04
|
顯示全部樓層
AU-D9, 內部看起來,就是老日外銷用的,用料真的比不上內銷機種.
順便轉貼一點資料:
http://www.audiokarma.org/forums/showthread.php?t=18778
[B]The fasterst Sansui amp[/B] known to man
~~~~
*****
I've made a small list for comparison, but did I forget any faster Sansui model? As you'll see the AU-D11 has the best slew rate figure I could find on any Sansui!!
AU-D11
Slew rate: 350V/µSec (!)
Rise time: 0,8µSec (Although TOTL model, why slower rise time then late seventies designs?)
AU-D9
Slew rate: 300V/µSec.
Rise time: 0,8µSec
AU-X1
Slew rate: 260V/µSec.
Rise time: 0,5µSec
AU-919
Slew rate: 200V/µSec.
Rise time: 0,5µSec
AU-X1111
Slew rate: 150V/µSec.
Rise time: 0,5µSec
Au-G90X and B-2102
Slew rate: 350V/µSec.
Rise time: 0,5µSec
But here is the King
AU-D11 II
Slew rate: 400V/µSec.
Rise time: 0,5µSec
*
*
*
Warren:
Based on my experience at Harman Kardon, I would say that an amp that has an open loop bandwidth that exceeds the human hearing range will sound good. Amps with open loop bandwidth into the RF range will be impossible to stabilize; they will oscillate and blow output transistors. The AU-X1 is notorious for this. I recently worked on one and after modifying to make it stable, it had an open lop bandwidth of 30kHz. with the feedback loop closed, it was wider, of course. Then I bandwidth limited the amp at the input to 50KHz, so it wouldn't amplify nearby radio stations. When it was done the amp sounded wonderful. High slew rate is a good idea but there is such a thing as taking it too far. |
|