新手上路
五星級會員
- 舊站積分
- 24194
- 舊站發表文章數
- 3046
|
樓主 |
發表於 2017-11-25 00:00:28
|
顯示全部樓層
Re: PASS ONO MC 唱放求助
原發表者是 HENRYK
[B]我這台DS版的ONO裝好近十年了, 聽MM正常,但MC有一邊時好時壞,
所謂壞是震盪聲,根本不能聽.但有時候 卻是正常的.
幾個工作點的電壓都算是正常,MC放大第一級的電壓在PASS原版電路上標示15V,但我的左右聲道都是12V左右,這應該影響不大.
想動烙鐵拆換JFET晶體 ,這又是一件大工程.
不知前輩們有何建議? 謝謝! [/B]
回到最原始的疑問, 臭蟲據推測應該就是MC輸入端的電容,原來賣我電路板的德國人也有相同的問題.....
MC Input Capacitor
With 2 of my moving coil pick-ups I heard a kind of crackle – not a hum – from my loudspeaker. From one of them it was so quiet that the operating noise of the record disc covers this crackle, from the other pick-up I could hear it even in the break between 2 compositions. I could influence the loudness of this noise with the amplification factor of the MC input stage, so it was obvious that it was produced in the input stage of the MC amplifier.
This noise was a periodical oscillation and such a behaviour must have something to do with capacitors and inductors. As a consequence I start thinking about the input capacitor C29. It exists an excellent FAQ about everything around pick-ups from Arlt van den Hul which you can find at his homepage. In it he described that a MC pick-up don』t need a capacitor as a load, however even capacitors above 100nF don』t have a noticable influence because of the very low coil inductance.
I confirmed this statement with my own tests. Therefore I connected capacitors in parallel to the 100pF input capacitor with a cinch adaptor – starting with 220pF – and finally I installed a 1nF Wima FKP2. The noise is totally gone and there isn』t any oscillation left. The MC input signal with a tone arm lifted up is nearly as quite as a line signal at my VV5 preamplifier. There is also a tonal difference to the situation before, the pick-ups are slightly more open.
德國人說 他把輸入電容從100pF加大到1nF,震盪聲就不見了! |
|