新手上路
四星級會員
- 舊站積分
- 3004
- 舊站發表文章數
- 1387
|
發表於 2012-11-28 09:12:59
|
顯示全部樓層
原發表者是 Lychee888
[B]
Thank you for the heads-up! I cannot find the card that you recommended on Amazon. Is it an internal sound card? I am using a notebook. I don't know if I'll be able to replace the integrated sound card. Will an external sound card be more feasible in my case? My other question is the phono preamp. How important is the phono preamp in the transfer? Can I just buy a turntable with phono preamp, such as Audio Technical AT LP 120? How much quality will I gain using a separate phono preamp in the vinyl to cd transfer? [/B]
You're welcome. The Creative Labs Audigy 2 sound card has many versions. But they are all based on a same chip +/- software features. All you will need is the basic Audigy 2 sound card for 2 channel recording. The surround sound features (4.1, 5.1 or 7.1) don't matter at all. So The one I picked up was less than $20 and it features surround sound 7.1. Audigy 1 is too old so look for Audigy 2 instead.
Just visit eBay and search for creative Audigy 2. You will find many of them. Some may be on PCMCIA (for old notebook computers), some may be external USB/firewire (more expensive), PCI (cheap) or PCIe (expensive).
The one I use is a PCI internal that cost only $18 including shipping. The Audigy 2 chip features 24 bit oversampling at up to 196 KHZ. It is the best among all cheap sound cards I could find. You can use an USB external Audigy 2 adapter. But imagine it will need an external power supply and a USB cable. The best solution is to use an old computer and install a cheap PCI card. Set it up a few feet away from your turntable and preamp. This is my setup.
A phono preamp is extremely critical for the sound quality of your audio system. For recording LP you only use the RIAA equalizer. So the RIAA equalizer needs to be a good one. I can turn up the volume to 5 o'clock and my audio is still sounds great and noiseless. Cheap phono preamps usually will give hum/noise beyond 12 o'clock. My phono preamp is a Yamaha C2.
I don't know about Audio Technica AT-120. My strategy about buying audio equipment is either buy very cheap or buy the highest end that I can afford. I don't spend for equipments in the mid range because I know I will have to replace them eventually. You may try to look for used Yamaha receivers that integrate tuner, phoro preamp and power amp in one unit. You should be able to find some on eBay.
Good luck. |
|