新手上路
五星級會員
- 舊站積分
- 4615
- 舊站發表文章數
- 3354
|
發表於 2010-5-3 12:30:11
|
顯示全部樓層
Velodyne:(FSX-12 Owner's Manual 4~5 頁)
Low-pass crossover- 40 to 120Hz
All inputs sum the left and right channels together, with the resulting signal passing through an adjustable low-pass crossover before being amplified. The crossover control allows you to adjust the upper limit of the subwoofer's frequency response from 40 to 120Hz. The subwoofer's response will begin rolling off above the frequency you set this control to. You should set the crossover frequency to obtain a smooth and seamless transition from the subwoofer to the main speakers in your system. If your main speakers are smaller units with limited low frequency output, you may wish to choose a higher frequency (such as 100-120Hz) than you would with larger speakers which have greater low frequency output. With larger speakers, you might start with this control set lower, such as 80Hz.
A bypass switch is also provided if you wish to use an external crossover. If you are not using an external crossover, we recommend that you use the one provided within the unit for optimum performance!
Subwoofer Direct switch- In/Out
This switch allows the electronic crossover circuitry to be removed from the signal path. This is required in certain installations which route the signal through external processors with a crossover circuit of their own, such as the new digital units. Simply move the switch to OUT to disengage the built in crossover. For all other installations which do not have a separate electronic crossover we recommend you leave the internal crossover IN to provide optimum performance. |
|