忘記密碼
 立即註冊
查看: 2191|回覆: 34

switchcraft高頻專用頭團購意願調查.

  [複製鏈接]

1256

主題

1萬

回帖

200

積分

新手上路

五星級會員

舊站積分
557
舊站發表文章數
11806
發表於 2001-7-25 23:13:47 | 顯示全部樓層

switchcraft高頻專用頭團購意願調查.

Profeel兄去問到了最低八十幾塊的價格,可是一次要100顆,所以不知哪些朋友有興趣?[]

大家要湊100顆應該不難吧~!

--------------------------------------
 
[I][h5]SLEEPLESS IN SEATTLE[/h5][/I]-------------------------------------

28

主題

370

回帖

0

積分

新手上路

失業青年人

舊站積分
40
舊站發表文章數
387
 樓主| 發表於 2001-7-26 01:55:22 | 顯示全部樓層
喂~~~~95塊啦~~~
而且現在不知道漲價了沒
問到價錢再PO上來看看


SWITCHCRAFT RF PLUG規格圖http://www.switchcraft.com/produ ... -145b_schematic.pdf



[img]http://photo.kimo.com.tw/profeellau/ab1/p21.gif">
RF-PLUGS RF PHONO PLUGS
Coaxial phono connectors feature low-loss nylon insulation and are ideally suited to RF applications where semi-permanent connection of moderate power handling capability is required. Perfect for applications where space is at a premium and cost is important. RF-Jax® jacks and RF-Plug® plugs have been used successfully to 1kW at 30 MHz.



關於耳朵的尊嚴問題

當一個人意識到耳朵也有尊嚴的時候,就算他有一大堆未來的計劃要去實現,一卡車的夢想要去實踐,他也希望至少每天回到自己房間的時候,可以聽到該聽的聲音。這就是耳朵的尊嚴


1256

主題

1萬

回帖

200

積分

新手上路

五星級會員

舊站積分
557
舊站發表文章數
11806
發表於 2001-7-26 02:38:22 | 顯示全部樓層
sorry sorry,一時不查.....[]
老周出國了嗎?
這個他應該有興趣!

--------------------------------------
 
[I][h5]SLEEPLESS IN SEATTLE[/h5][/I]-------------------------------------

10

主題

299

回帖

0

積分

新手上路

酒桶.煙罐...咖啡狂

舊站積分
61
舊站發表文章數
230
發表於 2001-7-26 09:42:39 | 顯示全部樓層
高頻 ? 多高 ?
RF 信號專用嗎 ? 如果是..
那為何不直接改成BNC 接頭 / 座 ?
不管是75歐姆.50歐姆組抗都合適呀..
信號的街頭端路損也比這種端子好呀...

不是亂講話..只是一點點懷疑的疑問..

玩...玩過頭啦.

1256

主題

1萬

回帖

200

積分

新手上路

五星級會員

舊站積分
557
舊站發表文章數
11806
發表於 2001-7-26 16:40:46 | 顯示全部樓層
主要是做"數位同軸線"端子居多,如原廠說的RF-Plug® plugs have been used successfully to 1kW at 30 MHz.

這是不少國外做"上萬"數位同軸線用的材料,裡面包的是RG179....[]

--------------------------------------
 
[I][h5]SLEEPLESS IN SEATTLE[/h5][/I]-------------------------------------

249

主題

3萬

回帖

220

積分

新手上路

上將

舊站積分
11603
舊站發表文章數
26283
發表於 2001-7-26 18:47:05 | 顯示全部樓層
高頻 ? 多高 ?
RF 信號專用嗎 ? 如果是..
那為何不直接改成BNC 接頭 / 座 ?
不管是75歐姆.50歐姆組抗都合適呀..
信號的街頭端路損也比這種端子好呀...

不是亂講話..只是一點點懷疑的疑問..

玩...玩過頭啦.

\那為何不直接改成BNC 接頭 / 座 ?
不管是75歐姆.50歐姆組抗都合適呀..
◎BNC 接頭 / 座 也有分75歐姆.50歐姆的歐!要求較高的是不能通用的如發射機,以免電壓駐波比過高導致輸出晶體燒燬!

28

主題

370

回帖

0

積分

新手上路

失業青年人

舊站積分
40
舊站發表文章數
387
 樓主| 發表於 2001-7-26 22:04:01 | 顯示全部樓層
50 Ohm 與75 Ohm 的差別
50的針比較粗喔   

Technical References

50 Ohm vs. 75 Ohm
Overview - The traditional usage of 50 Ohm BNC connectors on 75 Ohm cable with analog equipment (video & telco) has little distortion effect on the signal at frequencies below 300 MHz.
[img]http://photo.kimo.com.tw/profeellau/ab1/p22.gif">
[img]http://photo.kimo.com.tw/profeellau/ab1/p23.gif">
However, digital signals in video and telephony applications have necessitated the usage of 75 Ohm connectors because mismatched 50 Ohm connectors cause attenuation of the digital signal resulting in slower rise time of the signal』s square waves. This distortion of the signal can cause transmission errors. Also, impedance mismatched connections cause reflections of the signal returning to the source known as return loss. Perhaps one mismatched connection will not have a noticeable effect on system performance, but multiple mismatched connections in the link between the source and destination have a cumulative effect causing possible distortion of the transmitted signal.

Physical differences - In contrast to the 50 Ohm plug, the 75 Ohm plug does not have extended dielectric around its outer spring fingers; air has a higher impedance constant than solid dielectric material. Also, the 75 Ohm plug』s center pin has the same diameter in the rear area (where the pin is crimped) as in the front mating interface area. The 50 Ohm plug』s center pin has a thicker diameter in the rear area where it is crimped. Both pins of 50 Ohm and 75 Ohm plugs have the same diameter in the mating area. Therefore, both 50 Ohm and 75 Ohm connectors mate mechanically without any physical damage. Furthermore, the 75 Ohm connector』s dielectric is made of Teflon because of its higher impedance properties than Delrin, which is typically used in 50 Ohm connectors. Nevertheless, the 50 Ohm plug is adequate for analog applications.

Tooling - Another consideration is the tooling for 75 Ohm pins. Although some crimp tools have 0.042」 crimp hex cavities designed for 75 Ohm pins in the same die set used for crimping sleeves and 50 Ohm pins (0.068」 hex), experience has taught that this 0.042」 cavity is not reliable because the tool loosens with use causing inadequate 75 Ohm pin crimping; the 8 point or 12 point center pin crimper is recommended.


95

主題

5152

回帖

0

積分

新手上路

五星級會員

舊站積分
3
舊站發表文章數
4822
發表於 2001-7-27 17:34:23 | 顯示全部樓層
金巴我先訂20個.
上星期有跟你先提起過
A-LI-YADO[;)]

1256

主題

1萬

回帖

200

積分

新手上路

五星級會員

舊站積分
557
舊站發表文章數
11806
發表於 2001-7-27 19:01:19 | 顯示全部樓層
我也20個.

--------------------------------------
 
[I][h5]SLEEPLESS IN SEATTLE[/h5][/I]-------------------------------------

24

主題

149

回帖

0

積分

新手上路

二星級會員

舊站積分
0
舊站發表文章數
178
發表於 2001-7-27 22:01:55 | 顯示全部樓層
我要30個。另外我可以買75歐姆的BNC接頭嗎?一樣30個。謝謝。
您需要登錄後才可以回帖 登錄 | 立即註冊

本版積分規則

Archiver|MyAV視聽商情網 test

GMT+8, 2026-11-20 05:26 , Processed in 0.089371 second(s), 41 queries .

Powered by MyAV!

快速回覆 返回頂部 返回列表